This 3D Printed bracket holds a stepper motor with the shaft parallel to your 3030 extrusion. Models are available on grabCAD.
Model for the standard robot configuration, version 2.3, hosted on grabCAD.
A design to remotely mount your i2c circuit board on the 3030 rails. Designed for 3D printing, available on grabCAD
Student-designed bracket for Raspberry Pi, that seats the i2c circuit board level with the bracket. See details in grabCAD
A prototype version of a conveyor to mount on SCUTTLE. This requires some OTS parts and some 3D printing, plus electronics. See details in the grabCAD post.
3D Printable bracket to mount Jetson Nano on SCUTTLE Robot chassis.
3D Printable camera bracket on grabCAD
3D Printable Bracket for INA219 current sensor to mount on your motor driver. This sensor can read out Current, Voltage, and Power. The wiring setup for SCUTTLE motor driver is shown in the diagram. Always check the SCUTTLE wiring guide…